View Single Post
  #8  
Old 05-26-2013, 03:13 PM
mark andrews mark andrews is offline
Registered User
 
Join Date: Aug 2003
Location: London
Posts: 148
Old thread I know..........

If the original poster still wants plans for above console give me a shout.... Wouldnt normally do that but as you in NZ.....

Just a note, If a dj console was made from solid oak, It would have to be priced at about 5000........ If any of my consoles were made in hard wood, The hard wood alone would cost more than what I'm selling at.

LN-CC is not cheap.... But when you start taking off their (little) amount of commission for all the hard work, PR, Photo shoots etc, Then VAT @ 20%... Its soon brings down whats left in my pocket, Which I also have to hand over 20% tax on

I must of spent about a month designing the console refereed to.

I think 1500 is pretty good value myself.

Last edited by mark andrews : 05-26-2013 at 03:15 PM.
Reply With Quote