View Single Post
  #19  
Old 02-15-2013, 02:27 AM
bossa nolyx bossa nolyx is offline
Registered User
 
Join Date: Apr 2008
Location: Berlin, Germany
Posts: 211
Quote:
Originally Posted by Ross H
So to confirm, the nano patch dial would be used to control the booth's monitor and the booth dial on the mixer will be used to control the recording levels?

Does it affect the recording quality of the audio at all?

Thanks again for this tip...appreciated.
Yes, that's it.


The recording quality is not affected. You may only slightly increase the noise level on your booth monitor because of the lower output signal. This is what every volume control does.




Don't forget to use the correct ports. The image of the RCA cord is only intended as an example of a Y-cable.

Last edited by bossa nolyx : 02-15-2013 at 02:30 AM.
Reply With Quote