Thread: Pictures
View Single Post
  #5  
Old 08-17-2004, 08:27 PM
allen allen is offline
Registered User
 
Join Date: Dec 1969
Posts: 462
It's not that hard

It's not hard at all to make a motorized console. It just requires more attention to braceing and allowing for the movment. The front angle part is hinged and is moved using a linear actuator that i got off ebay for $70 shipped. I think the acutator is intended for a bed. It inclued the remote and no special wireing was requred. The total cost was under 300 including the ectra piece of laminate that i had to buy cause i messed up onece. About 50 for the wood, 70 for the motor and around 150 for the 2 sheets of black laminate with all the gule, trimmer, and routher bit. Here is another pic of the underside.
Allen
Attached Images
File Type: jpg consloe small.jpg (56.0 KB, 6887 views)
Reply With Quote